
4. Snap out and slide out toward rear of car.
Note: it may help to have glovebox drawer open
to perform this step.
(Notice the three snap clips that hold these side
panels in place. Shown circled in photo below.)
CLIP
CLIP
CLIP
Overcoming the three clips should not require
any additional tools – just snap the panel out,
rearwards. Note that the top clip can be a bit
difficult, usually requiring a bit more
aggressive cocking and pull of the panel to
overcome it.
Glovebox
With access panels removed, mObridge visible. SD
card slot for updates is on bottom side in this depiction
(toward floor of car).
The card springs and clicks into the slot, so as to be
protruding only about 1mm. From the surface of the
case. To remove, depress the card and it will likewise
click and spring out.
Card slot this side
Porsche Under-dash Installation Notes
(997 shown, 987 very similar)
This piece in 987
Note: Alternate Step-by-Step Instructions
for CDR24 or PCM2 removal in 997 and 987
can be found later in this document.
page 5 of 14
Comments to this Manuals